英文鍍鋅設(shè)備報(bào)價(jià)清單Technical parameters of LZ 8 / 400 direct wire drawing machine

1) Equipment composition

A) ZNF800 LZ 8 / 400

As a platform

2) Scope of operation

A) Incoming line strength: 1,100 Mpa

 Bb) Maxmaximum inlet line: Φ 2.0mm, outlet diameter Φ 1.0mm,

C) Maximum linear speed: 25m / s.

3) Water pressure and air pressure

 A) Water pressure:> 0.1MPa.（2）

Air pressure:> 0.5MPa.

4) Motor power

A) Wmachine motor:

3 * 15KW + 5 * 11KW AC change

Frequency motor.

5) Main technical parameters

 A) Reel diameter: Φ 400mm;

Number of rolls: 8 rolls.

B) Maximum design speed: 25m / s;

 C) Maximum inlet line diameter: Φ 2.0mm, minimum outlet line diameter: Φ 0.84 mm (LZ 400-8)

 D) Incoming line strength: 1,100 MPa.

E) Number of wire drawing molds: 8, mold cooling mode: direct water cooling.

 F) Transmission mode of wire drawing machine:

i. LZ 8 / 400:1 # ~4 # adopts two-stage narrow V belt drive, 5 # ~8 # adopts single-stage narrow V belt deceleration.

 G) Outer diameter of I-wheel of unwinding machine: Φ800mm. Layout mode: mechanical automatic damping wiring mode.

 H) Water pressure requirement: 0.2 Mpa, air pressure requirement: 0.5MPa.

I) Power of the equipment: LZ 8 / 400:15KW 8=120KW.

6) Main technical parameters of LZ 8 / 400 direct wire drawing machine

(1) Rack:

 D) The thickness of the whole body platform plate is 14mm, and the apron thickness is 10mm.

E) Break device, requiring each machine and receiver to have a break stop board.

F) Lighting lamp is set at the top of the protective cover

(2) Drum specification

 E) Number of rolls: 8 reels, drum diameter: φ400mm Reel material: cast steel ZG 270- -500, working surface

Spraying tungsten carbide (WC) carbide carbide powder, good wear resistance.

 F) Smooth operation, radial running and end running speed are 0.1mm

 G) The hardening working face height is not less than 60mm, the surface hardness is> HRC 60, and the service life is more than three years.

H) It has good cooling performance, requiring self-scale removal and narrow seam water cooling inside the drum, with good cooling effect and convenient maintenance.

(3) Module box

 D) The mold box is made of dry brushed powder drawing, cooling water cavity and lubricating powder cavity, mold cooling: direct water cooling, replace the mold

 It is convenient.